During all these phases of developments, we have maintained the most possible quality standards and frequently tested our products. Our production is ISO 9002 approved.
We are registered with D&B’s global under RMS D-U-N-S No 64-548-3012.
We have many of our important gloves tested against many risks and have them CE certified for different categories. Our gloves are mainly tested against, Mechanical risks, Heat, Cold and Chainsaw cut.
Materials that we use in our gloves have different level of protection and are divided in Category 1 and category 2.
Category 1 glove is used for minimum risk and is labeled with CE label
Category 2 glove is used for Medium risk glove and the glove is tested and approved by an EU notified body.
General Requirements for EN 420 certification:
The Glove is for right Protection.
It is easy to wear.
The Glove material should be made of harmless material.
The pH level of the leather should be 3.5-9.5.
Chrome level should be 3mg/Kg or lesser.
The fingers must meet the dexterity standard.
The Glove should accompany with the instructional manual.
Sizes of the gloves should be according to the manual.
The glove should be labeled properly with pictogram, safety level, article number.
Gloves for Mechanical Risk, EN 388
In this standard, the glove is tested against following risk:
Abrasion resistance
Cut resistance
Tear resistance
Puncture resistance
Gloves for Protection against Thermal Risks, EN 407
In this standard, the glove is tested against following risk:
Resistance against combustion
Resistance against contact heat
Resistance against convective heat
Resistance against radiation heat
Resistance against drops of molten metal
Gloves for protection against Hand Held Chain Saw, EN 381-7
In this standard, the glove is tested against following risk:
Glove is tested for EN 420
Resistance to Chainsaw Cut
Gloves for Protection against COLD, EN 511
In this standard, the glove is tested against following risk:
Note: Above information is only a summary and the full information is only available on request with copies of certificates issued by concerned institutions.
During all these phases of developments, we have maintained the most possible quality standards and frequently tested our products. Our production is ISO 9002 approved. 
Gloves for Mechanical Risk, EN 388
Gloves for Protection against Thermal Risks, EN 407
Gloves for protection against Hand Held Chain Saw, EN 381-7 
Gloves for Protection against COLD, EN 511
